Rod Holders - Cannon Magnum 5 ST Owner's Manual

AnglingOutpost.com
REPLACING THE CLUTCH PAD
To replace the clutch pad, follow the steps for removing
the spool. Once the spool is removed, you have access to
the clutch pad. (Figure 18) Simply pull it off the shaft and
replace. Reassemble the spool and cover in the reverse
order.
ATTACHING THE ROD HOLDER(S)
The locking rod holder(s) incorporate a locking tooth
design which can be easily adjusted every 15° with the
soft grip knob. The symmetrical design will allow mount-
ing of the rod holder on either side of the downrigger or
two rod holders at the same time. The unique two piece
design allows independent adjustment of the rod holder
and the rod holder arm in two axes.
(Figure 19)
Caution: This rod holder is intended for use of up to 30
lb. test line only and is not recommended for use with
any tackle IGFA (International Game Fish Association)
rated higher than 30 lb. A safety strap (not included) is
recommended for all applications.
NOTE: The rod holder assembly is not covered
under warranty when used with tackle above 30 lbs.
Equipment placed in the rod holders and the loss
thereof is the responsibility of the user and is in no
way warranted by Johnson Outdoors, Inc. Mounting
must be in accordance with the above instructions
and pictures to comply with the product warranty.
To install the rod holder(s):
1) Fasten rod holder to rod holder elbow using supplied
spring and knob.
2 ) Attach the rod holder to the downrigger on either side
using the supplied spring and knob. (Figure 20)
3) Repeat the above steps for the other side if (2) rod
holders are to be mounted.
The rod holders can be adjusted by loosening either
knob until the locking teeth are free from each other.
Rotate the rod holder or arm to the desired position and
1 2
re-tighten knob. (Figure 21)
www.cannondownriggers.com
AnglingOutpost.com
FIGURE 18
FIGURE 19
FIGURE 20
FIGURE 21
1-888-356-5022
3 9
1-888-356-5022