Uni-Troll; Attaching The Rod Holder - Cannon Uni-Troll 10 Owner's Manual

Attaching the Rod Holder

The positive lock rod holder incorporates a
locking disk that allows the rod holder to be
aligned in 15 degree increments. Slide the rod
holder tube into the clamp to the desired position
within the recommended area (see below).
Be sure the angled shoulders are facing up.
Place the locking disk into the mating recess of
the frame.
Slip the clamp arms in place where the
obround tab on the disk fits into the slot on the
clamp. Slide the star washer between the arm of
the clamp and the frame. Place the flat washer
onto the bolt. Then insert the bolt with washer
through the clamp by entering the disk, going
through the frame, the star washer, and out the
other side of the clamp. Tighten the nut to secure
the rod holder. Reposition the rod holder by
loosening the nut and adjusting the tilt.
Single Rod Holder Assembly
Recommended
Area to Clamp
Rod Holder
Angled
Shoulder
10
Dual Rod Holder Assembly
Star Washer
Placement
CAUTION: This rod holder is intended for use
of up to 30 lb. test line only, and is not
recommended for use with any tackle IGFA
rated higher than 30 lb. A safety strap (not
included) is recommended for all
applications.
The rod holder assembly is not warranted
when used with tackle above 30 lbs.
Equipment placed in the rod holders and the
loss thereof is the responsibility of the user
and is in no way warranted by JOHNSON
OUTDOORS, INC. Mounting must be in
accordance with the above instructions and
diagram to be warranted.