7 feet from the front of the heater. 9. In order to prevent equipment damage, protect with a ground 3. Do not leave heater unattended while in operation. fault device such as Chromalox STAR-TG series monitor. SAVE THESE INSTRUCTIONS 4. Always disconnect heater when not in use.
8. Connect entrance wiring to pigtail leads “L1” and “L2”. Connect ground to screw provided. 9. Inspect to make sure wiring is per “Single Phase Wiring” above. OPTIONAL ACCESSORIES Chromalox STAR series radiant heaters can be field modified by Plugs adding optional kits. Refer to Chart A and B to select the proper kit.
Page 4
3 Pole, 4 Wire 15-50 C73.61 The above plugs are designed to be used with specific ranges of cable diameters. If not used with Chromalox Cable Kits, check cable man- ufacturers cable diameter to be sure plug fits selected cable.
8. Remove failed element and replace with a new element. before servicing or replacing heating elements. Replace only with genuine Chromalox "Arctic End" ele- ments. Use of other elements will cause excess temperatures The reflectors should be kept clean to obtain the maximum inside terminal box.
Page 6
RELATING HERETO, WHETHER BASED ON BREACH OF CONTRACT, TORT (INCLUDING NEGLIGENCE AND extent and in the manner that the same are warranted to Chromalox by Chromalox’s vendors, and then only STRICT LIABILITY) OR OTHER THEORIES, MUST BE COMMENCED WITHIN ONE (1) YEAR AFTER THE to the extent that Chromalox is reasonably able to enforce such warranty, it being understood Chromalox DATE OF SHIPMENT OR IT SHALL BE BARRED.
This manual is also suitable for:
Star-02a-81-pStar-02a-21-pStar-02a-71-pStar-02a-41-pStar-02a-61-pStar-05a-81-p...
Show all