Dirt Devil M08100 Owner's Manual page 5

Table of Contents

Advertisement

TO
INSTALL PAPER BAG: NOTE: CLEANER MUST BE USED WITH PAPER BAG.
1.
Place paper bag's intake hole against exhaust outlet. (Diagram 1)
2.
Slide paper bag as far as possible over exhaust outlet.
3.
Replace cloth Dirt Devil bag over the new paper bag insert.
NOTE: See pg. 3 for detail information on removal and replacing cloth bag.
TO
CONVERT DlRT DEVIL TO A HANDY BLOWER UNIT:
1. Remove cloth and paper bags.
2. Snap your Dirt Devil attachment hose into the exhaust as shown. (Diagram 2)
F. BRUSH REMOVAL & INSTALLATION
If your belt fails to drive brush, it needs to be replaced.
1. Lift the black ulua and remove belt, as described in section A, instruction #6.
I
Belt Style:
1
I
2. Remove the metal nozzle guard by taking out the two screws as shown. (Diagram3) Grasp belt and brush assembly in the center of the
wooden brush roll. Pull straight out. (Diagram 4) Replace belt or brush, if necessary, at this time. *Use a Phillips screwdriver to remove the
nozzle guard. Screwdriver not included with cleaner.
3. When the brush has become slightly worn or where heavy brushing is desired, replace brush roll. NOTE: ARROWS ON BRUSA ROLLAND
METAL NOZZLE GUARD MUST
BE
POINTING IN THE SAME DIRECTION. THIS ASSURES PROPER BRUSH ROTATION.
INSTALAR ELA BOLSA DE PAPEL: NOTA LA ASPIRADORA SE DEBE USAR CON LA BOLSA DE PAPEL PUESTA.
1. Coloque la abertura del saco contra la salida del adaptador. (Diagrama 1)
2. Pase la bolsa de papel lo mas posible por encirna de la salida.
3. Vuelva a colocar el sac0 de tela Dirt Devil por encima de la bolsa de papel.
PARA CONVERTIR EL DlRT DEVIL EN UNA UNIDAD SOPLADORA:
1. Quite ambos sacos (de tela y de papel).
2. Coloque la manguera Dirt Devil sobre la salida, tal y corno se ve en la foto (Diagrarna 2)
F. QUITAR E INSTALAR EL CEPILLO Si la cinta no gira el cepillo, debe reemplazarse.
1. Levante el tapon negro de la abertura y quite la correa, corno se describio en la Seccion B, instruccion 6.
2. Quite el guardabocas de metal sacando 10s dos tornillos corno se muestra. (Diagrama 3) Tome el montaje de la cinta y el cepillo por el centro
del rollo del cepillo. Tire hacia fuera. (Diagrarna 4) Reemplace la cinta ylo el cepillo si es necesario. *Utilice un destornillador Phillips para
quitar el guardabocas. El destornillador no esta incluido con la aspiradora.
3. Cuando el cepillo esta ligerament desgastado, o si se necesita un cepillado mas fuerte, reemplace el rollo del cepillo. NOTA: LAS FLECHAS
QUE SE ENCUENTRAN EN EL ROLL0 DEL CEPILLO Y EN EL GUARDABOCAS DEBEN APUNTAR A LA MlSMA DlRECClON PARAASE-
GURAR LA ROTAClON CORRECTA DEL CEPILLO.
POUR METTRE EN PLACE LE SAC EN PAPIER: REMARQUE:
c
ASPIRATEUR DOIT ~ T R E UTILISE AVEC UN SAC EN PAPIER.
1. Mettre I'ouverture d'adrnission du sac en papier contre I'orifice d' echappement (Schemal)
2. Glisser le sac en papier aussi loin que possible sur I'orifice d'echappement.
3. Remettre le sac en tissu du Dirt Devil par dessus le nouveau sac en papier.
REMARQUE: Pour de plus arnples renseignements sur I'installation et le retrait des sacs en toile, voir page 3.
Typ de Courroie:
POUR TRANSFORMER LE DlRT DEVIL EN UN SOUFFLEUR COMMODE:
1.
Enlever les sacs en tissu et en papier.
2.
Emboiter le tuyau du Dirt Devil dans I'echappement comme le montre le schema. (Schema 2)
F.
ENLEVER ET INSTALLER LA BROSSE Si la courroie ne fait plus marcher la brosse, on doit remplacer la courroie.
1. Soulever le bouchon noir et enlever la courroie, tel que decrit dans la section 8, instruction numero 6.
2.
Enlever la protection en metal du suceur en enlevant les deux vis, tel qu'indique. (Schema 3) Empoigner I'assemblage courroie/brosse par le milieu
du cylindre en bois de la brosse. Tirer tout droit vers I'exterieur. (Schema 4) Remplacer la courroie etlou la brosse, si nfkessaire, en mkme temps.
*UTILISER UN TOURNEVIS PHILLIPS POUR ENLEVER LA PROTECTION DU SUCEUR. LE TOURNEVIS N'EST PAS COMPRIS AVEC L'ASPIRATEUR.
3. Lorsque la brosse apparait legerement usee ou lorsqu' on desire un brossage plus efficace, remplacer la brosse. REMARQUE: IL FAUT QUE LES
FLECHES DE LA BROSSE ET CELLES DU PROTECTEUR METALLIQUE DU SUCEUR SE TROUVENT DANS LA M ~ M E DIRECTION. CECl
5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents