Channel Master DVR+ Quick Start Manual page 8

Programming the Remote Control
The remote is capable of controlling basic functions of most TVs (volume, mute,
power, input) and audio devices. To program the remote control to operate your TV
or audio device, use the Easy Scan or Code Entry method.
Note: If you wait at least 10 seconds between any step in these procedures, the
remote exits its programming mode, and you will need to restart the procedure
Easy Scan
Follow this procedure to program the remote by cycling through manufacturer codes.
1
2
3
4
Button
Number
1
2
3
4
5
6
7
8
9
0
4
SETUP
or
TV Audio
Insignia Bose
LG Denon
Mitsubishi LG
Panasonic Onkyo
Philips/
Panasonic
Magnavox
Samsung
Philips
(default)
Sharp Pioneer
Sony Samsung
Toshiba Sony
Vizio Yamaha
OK
SELECT
Turn on your TV or audio device.
Hold down the Setup button until the
Off/On button blinks twice, then release the
button.
To control your TV, press the Red button.
To control your audio device, press the Green
button. The Off/On button blinks once.
Choose the best option below:
If you have a TV or audio device listed
•
in the table on the left (fastest method):
Using the numeric keypad, hold down the
numbered button corresponding to the
manufacturer shown in the table on the left.
Hold down the button until your TV or audio
device turns off, then release the button.
The Off/On button blinks twice to indicate
that the code has been programmed
successfully.
or:
• If you do not have a TV or audio device
listed in the table on the left: Hold down
OK/Select until your TV turns off, then
release the button. The Off/On button
blinks twice to indicate that the code has
been programmed successfully.
.