Table of Contents
Advertisement
Select TAB
The SELECT TAB allows the user to select the relevant IP Unit in order to change its settings or to upgrade
its version.
1. From the Unit selection list, select the relevant IP product. In case of multiple sites, it is advised to use
the filter under the Unit Type field.
2. Once the desired unit has been selected, notice the
order to change the selected unit's settings on the local PC that is running the VNSetup, a unique
password must be entered.
Note: This is correct for BIOS from version 1.0.10.86 and later (ViconNet version 3).
3. Password authentication
There are two authentication options. You can either authenticate a specific unit, by entering its
password, or use a Nucleus authentication, allowing you access to all units in the network.
3.1. Unit authentication - On the Unit password field, enter the unit password and press the Add
password button. Once approved, notice that the
proceed to next phase.
Note: The unit password is supplied on the sticker with the MAC address in the camera package.
3.2. Nucleus authentication - On the Nucleus login field, enter a valid Nucleus IP address and
password and press the Login button. Once approved, notice that the
disappeared from all the units currently connected to the selected Nucleus and the user may
proceed to next phase.
4. Press the Select button on the lower section of the screen.
5. The selected unit appears on the Selected unit section on the top of the screen and settings can be
changed.
2
3
19
icon, indicating a password protected unit. In
Select
3.2
4
XX181-02-00 Rev 1107 VN-855 Ver 3 IP Camera
icon has disappeared and the user may
icon has
Advertisement
Table of Contents
