Toshiba RAV-SM562KRT-E Installation Manual page 22

10
INDOOR UNIT OPERATION WHEN CONNECTED TO MULTIPLE UNITS
To change all the indoor addresses from an arbitrary wired remote controller
(When the setup operation with automatic address has finished, this change is available.)
Contents : Using an arbitrary wired remote controller, the indoor unit address can be changed for each same
refrigerant cycle line.
* Change the address in the address check/change mode.
(Operation while air conditioner stops)
Procedure example 1
While the operation stops, change the setup.
(Be sure to stop the operation of the unit.)
3-2, 4-2, 5-2
Procedure
Push simultaneously
display part flashes as shown below. Check the displayed ITEM CODE is [10].
• When the ITEM CODE is other than [10], push
1
repeat procedure from the first step.
(After pushing
1 minute.)
(For a group control, No. of the firstly displayed indoor unit becomes the header unit.)
Every pushing
2 order. Select the indoor unit of which setup is changed.
In this time, the position of the indoor unit of which setup is changed can be confirmed
because fan and flap of the selected indoor unit operate.
Using temp. setup
3-1
specify ITEM CODE [12]. (ITEM CODE [12]: Line address)
Using timer time
3-2
SET
Push button.
3-3
In this time, the setup finishes when the display changes from flashing to lighting.
Using temp. setup
4-1
specify ITEM CODE [13]. (ITEM CODE [13]: Indoor address)
Using timer time
4-2
In this time, the setup finishes when the display changes from flashing to lighting.
4-3
EN
Manual address setup procedure
7
SET DATA
SETTING
TEMP.
7
FILTER
RESET TEST
1
TEST
SET CL
+ + buttons for 4 seconds or more. After a while, the
TEST
button, operation of the remote controller is not accepted for approx.
UNIT
button, the indoor unit No. in the group control is displayed in
/ buttons,
/ buttons, change the line address from [3] to [2].
/ buttons,
/ buttons, change the indoor address from [3] to [2].
CODE No.
TEST
UNIT No.
R.C. No.
ON / OFF
3-1, 4-1, 5-1, 6
TIMER SET FAN MODE
2, 6
TIME SWING/FIX VENT
SET CL UNIT
3-3, 4-3, 5-3
Description
TEST
button to erase the display and
19
CODE No.
SET DATA SETTING TEST
UNIT No.
R.C. No.
(∗ Display changes according to
the model No. of indoor unit.)
Indoor unit No. before setup
change is displayed.
CODE No.
SET DATA SETTING TEST
UNIT No.
R.C. No.
CODE No.
SET DATA SETTING TEST
UNIT No.
R.C. No.
Indoor unit No. before setup
change is displayed.
CODE No.
SET DATA SETTING TEST
UNIT No.
R.C. No.
CODE No.
SET DATA SETTING TEST
UNIT No.
R.C. No.