Disassembly Instructions - Toshiba MXZ-2DM40VA Service Manual

12

DISASSEMBLY INSTRUCTIONS

<"Terminal with locking mechanism" Detaching points>
The terminal which has the locking mechanism can be detached as shown below.
There are 2 types ( Refer to (1) and (2)) of the terminal with locking mechanism.
The terminal without locking mechanism can be detached by pulling it out.
Check the shape of the terminal before detaching.
(1) Slide the sleeve and check if there is a locking lever or not.
Sleeve
Locking lever
12-1. MXZ-2DM40VA
OPERATING PROCEDURE
1. Removing the cabinet and the panels
(1) Remove the screw fixing the service panel.
(2) Pull down the service panel and remove it.
(3) Disconnect the power supply and indoor/outdoor con-
necting wire.
(4) Remove the screws fixing the top panel.
(5) Remove the top panel.
(6) Remove the screws fixing the cabinet.
(7) Remove the cabinet.
(8) Remove the screws fixing the back panel.
(9) Remove the back panel.
Photo 2
Screws of the
cabinet
OBH739A
Slide the sleeve.
Pull the terminal while
pushing the locking
lever.
Photo 1
Screws of the terminal
block support and the
back panel
Photo 3
50
(2) The terminal with this connector has the
locking mechanism.
Hold the sleeve, and
pull out the terminal
slowly.
Connector
NOTE: Turn OFF the power supply before disassembly.
PHOTOS
Screws of the
top panel
Hooks
Screws of the
back panel
Direction
to remove
Screws of the
Service panel