Toshiba MXZ-2DM40VA Service Manual page 54

OPERATING PROCEDURE
2. Removing the outdoor control P.C. board, the
outdoor power P.C. board and the noise filter P.C.
board
(1) Remove the service panel (Refer to 1).
(2) Remove the top panel, the cabinet, and the back
panel (Refer to 1).
(3) Disconnect all connectors and lead wires on the out-
door control P.C. board.
(4) Remove the outdoor control P.C. board.
(5) Remove the screws fixing the outdoor power P.C.
board.
(6) Disconnect all connectors and lead wires on the out-
door power P.C. board.
(7) Pull up the power P.C. board and remove it upward.
(8) Disconnect all connectors and lead wires on the noise
filter P.C. board.
(9) Remove the noise filter P.C. board.
3. Removing the reactor
(1) Remove the service panel (Refer to 1).
(2) Remove the top panel, cabinet, back panel, and the
electrical parts (Refer to 1 and 2).
(3) Disconnect the reactor lead wire from the terminal of
the reactor.
(4) Remove the screws of the reactor, and remove the
reactor.
4. Removing the fan motor
(1) Remove the service panel, the top panel, and the
cabinet (Refer to 1).
(2) Disconnect the connector CN931 on the outdoor con-
trol P.C. board.
(3) Remove the propeller fan.
(4) Remove the fan motor.
OBH739A
Photo 4
Screws of the
electrical parts
Photo 5
Screws of the outdoor
power P.C. board
Photo 6
Screws of the reactor
Photo 7
Screws of the outdoor fan motor
Propeller fan Propeller fan nut
54
PHOTOS
Separator
Sound
proof
felt