Local Codes - Desa IRONHAUS IKC42N Series Owner's Operation And Installation Manual

Table of Contents

Advertisement

Do not use this fireplace to cook
food or burn paper or other flam-
mable material.
This fireplace reaches high tem-
peratures. Keep children and
adults away from hot surface to
avoid burns or clothing ignition.
Fireplace will remain hot for a
time after shutdown. Allow sur-
face to cool before touching.
Carefully supervise young chil-
dren when they are in the room
with fireplace.
Keep the area around your
fireplace clear of combustible
materials, gasoline and other
flammable vapor or liquids. Do
not run fireplace where these
are used or stored.
1. For propane/LP fireplace, do not place
propane/LP supply tank(s) inside any
structure. Locate propane/LP supply
tank(s) outdoors. To prevent performance
problems, do not use propane/LP fuel tank
of less than 100 lbs. capacity.
2. If you smell gas
• shut off gas supply
• do not try to light any appliance
• do not touch any electrical switch; do
not use any phone in your building
• immediately call your gas supplier from
a neighbor's phone. Follow the gas
supplier's instructions
• if you cannot reach you gas supplier,
call the fire department.
Install and use fireplace with care. Follow all
local codes. In the absence to local codes,
use the current National Fuel Gas Code ANSI
Z223.1/NFPA 54* (USA) or the current CSA-
B149.1 Installation Code (Canada).
*Available from:
4
SAFeTy
Continued

LoCAL CodeS

www.ironhaus.com or www.desatech.com
3. Never install the fireplace
• in a recreational vehicle
• in windy or drafty areas where curtains
or other combustible (flammable)
objects can make contact with the
fireplace front
• in high traffic areas
4. Turn fireplace off and let cool before servic-
ing, installing or repairing. Only a qualified
service person should install, service or re-
pair this fireplace. Have fireplace inspected
annually by a qualified service person.
5. You must keep control compartments,
burners and circulating air passages clean.
More frequent cleaning may be needed due
to excessive lint and dust from carpeting,
bedding material, etc. Turn off the gas valve
and pilot light before cleaning fireplace.
6. Have venting system inspected annually by
a qualified service person. If needed, have
venting system cleaned or repaired. See
Cleaning and Maintenance, page 31.
7. Do not use any solid fuels (wood, coal,
paper, cardboard, etc.) in this fireplace.
Use only the gas type indicated on fire-
place nameplate.
8. This appliance, when installed, must be
electrically grounded in accordance with
local codes or, in the absence of local
codes, with the National Electrical Code,
ANSI/NFPA 70 or the Canadian Electrical
Code, CSA C22.1.
9. Do not use fireplace if any part has been
exposed to or under water. Immediately
call a qualified service person to arrange
for replacement of the unit.
10. Do not operate fireplace if any log is
broken.
11. Do not operate fireplace with glass door
removed, cracked or broken.
12. Provide adequate clearances around air
openings.
American National Standards Institute, Inc.
1430 Broadway
New York, NY 10018
National Fire Protection Association, Inc.
Batterymarch Park
Quincy, MA 02269
121334-01A

Advertisement

Table of Contents
loading

Table of Contents