Storage Of Gas Cylinders; Installation; Cleaning; A/C Operation - Dometic RC1700 EGP Operating Instructions Manual

Hide thumbs Also See for RC1700 EGP:
Table of Contents

Advertisement

GB

3. Storage of gas cylinders

Liquid gas cylinders should never be stored in unventilated areas or below
ground (funnel-shaped holes). Avoid direct sunlight. The gas cylinder should
not be exposed to temperatures in excess of 50°C.

4. Installation

To be installed horizontally on a smooth, firm or any other appropriate
surface. If necessary, adjust/align using a spirit level or a water-filled vessel.
There should be a distance of at least 10cm between the back of the unit
and any other object (wall).
Avoid placing unit in direct sunlight and next to other sources of heat.
For good air circulation the air vents on the top and under sides, as well as
at the back of the cooling unit must not be obstructed.
This will result in a good, energy-saving cooling system.

5. Cleaning

Prior to initial use and later after defrosting, or prior to a prolonged period
out of operation, clean the container and lid with luke-warm water and, if
necessary, washing-up liquid. Warning: do not inadvertently press or
force the opened door past its stop-point (this could cause the hinges
to break). Never use scouring or corrosive agents to clean the unit.
Wipe cleaned surfaces dry with a soft cloth.

6. A/C operation

Do not use any additional form of energy (batteries/gas).
Check that the supply voltage corresponds with the line-voltage data on the
type-plate (see back of unit).
(The following instructions refer in the main to coolers manufactured for the
United Kingdom).
The mains lead of your refrigerator is fitted with a non-rewirable moulded-on
13 amp plug containing a 3 amp fuse. It is a regular earthed plug for
connection to a regular earthed socket.
Due to the difference in the plugs used, an adapter will be necessary for
other countries.
If the fuse requires replacing at any time, the fuse cover/carrier should be
removed using a small screwdriver to lever it out. The old fuse should be
replaced by a 3 amp ASTA approved BS 1362 fuse and the fuse
cover/carrier must be refitted before the plug is used again.
27

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents