Honeywell LYNX Touch L5210 Series User Manual page 38

86(5 )81&7,216 86(5 )81&7,216 86(5 )81&7,216 86(5 )81&7,216
0HVVDJH 5HFRUGLQJ DQG 3OD\EDFN
7KH /<1; 7RXFK 0HVVDJH &HQWHU DOORZV \RX WR UHFRUG SOD\ DQG GHOHWH PHVVDJHV 7KH PD[LPXP PHVVDJH
GXUDWLRQ LV VHFRQGV
NOTES: (1) If the system loses electrical power, all messages will be erased.
(2) Message Play/Record will not be available if a report must be sent.
Entering Message Mode
Ready To Arm
Arm Away Arm Stay
Delay
10:18 AM June 8, 2010
Recording a Message
Ready To Arm
No items to display!
Add New Play
Ready To Arm
Message 1
Time Remaining : 184 Seconds
Record Play
Ready To Arm
Message 1 2:48 PM September 1, 2010
Message 2 5:09 PM September 5, 2010
Add New Play
NOTE: If you are trying to record a new message and the message center is already full, "Add New" will not be displayed. If the
message center is full all old messages must be deleted before new messages can be recorded. See the Deleting
Messages section.
1. With the system in the disarmed state, select the "Message"
Zones System
Message Phone
More
5200-100-014-V0
1. Select "Add New". The system displays the Record Message
Note: The System will display the total message recording time
Delete All Save
5200-100-045-V0
2. Select "Record", the system sounds a single tone. Speak into
Stopped
3. When you are finished recording your message, select. "Stop"
4. To listen to the message, select "Play".
5. If you wish to delete the message, select "Delete".
6. Record additional messages as required.
Delete
5200-100-046-V0
7. When you have finished recording, select "2". The system
8. To record additional messages (if recording time is available)
Delete All
5200-100-047-V0
icon from the Security Screen. The system displays the
Message screen.
screen.
available.
the microphone and record your message.
displays the recorded messages.
repeat steps 1 through 3.
² ²