Using the Tire Sealant and Compressor
Kit to Temporarily Seal and Inflate a
Punctured Tire
Follow these directions closely for correct sealant usage.
1. Do a safety check before proceeding. See If a Tire
Goes Flat on page 5-30.
2. Inspect the damaged tire.
The sealant cannot seal sidewall damage, large
punctures, or a tire that has unseated from
the wheel. See "Roadside Assistance Program" in
the owners manual.
Do not remove any objects that have penetrated
the tire.
5-34
3. Place the tire sealant and compressor kit (A) on the
ground and unwrap the sealant/air hose (G) from
the side of the compressor.
4. Remove the valve stem cap from the flat tire by
turning it counterclockwise.
5. Attach the sealant/air hose (G) onto the tire valve
stem. Turn it clockwise until it is tight.
Make sure the sealant and compressor kit On/Off
switch (D) is in the O (off) position.
6. Remove the air compressor accessory plug (C)
from the unit.
7. Plug the air compressor accessory plug (C) into an
accessory power outlet in the vehicle. See
"Accessory Power Outlet" in the owner manual.
Do not slam the door or close the window on the air
compressor accessory plug cord.
CAUTION:
{
Idling the engine in a closed-in place or with
the climate control system off can cause
deadly carbon monoxide (CO). See "Engine
Exhaust" in the owner manual.