Specifications - Centurion PoloPhone Installation Manual

SPECIFICATIONS

Operating Voltage
Quiescent
Current Draw
Maximum
Speech Volume
Wiring / Cabling
Ring tone
Call confirmation at entry panel
Wiring / Cabling distance
Gate / Door release
Handset Auxiliary Contact
Handset Indicator lens
Entry Panel illumination
Operating Temperature
Humidity
IP Rating
Surge Protection
* NB: If 12V DC gate motor supply dips when motors starts up and the intercom is being used
at the same time, the speech quality might be affected.
Page 4 - Polophone Intercom
12-14V DC (14V DC if powering handset)
Supplied from gate motor DC supply* or
separate 14V DC supply
150mA (+/- 60mA for a 1:1 system)
200mA
Adjustable at each entry panel and handset
2 polarized wires for speech, call and
gate/door lock release
Electronic while button is depressed, with
separate tones when calling from each entry
panel in a system or between groups of handsets
Yes
Max 150m - Refer to cable thickness on page 5
2A 12V AC/DC Potential free normally open
contact at entry panel. Door lock requires
separate power supply wired in series with contact
Potential free normally open contact. Requires
separate wiring to 2 wire bus. Contact rating:
2A @ 12V DC/AC
Accommodates 5mm LED. Requires separate
wiring to 2 wire bus.
Call buttons and labels backlit
-20°C to +50°C
0-90% non condensing
IP56
Yes