Wall Mount Installation - Centurion PoloPhone Installation Manual

ENTRY PANEL INSTALLATION
1A 1A 1A

Wall Mount Installation

Wall Mount Installation Wall Mount Installation
Position entry panel on wall adjacent Position entry panel on wall adjacent Position entry panel on wall adjacent
to entrance gate or door to entrance gate or door to entrance gate or door . . .
Mount at a height that allows Mount at a height that allows Mount at a height that allows
speaking into the system to be speaking into the system to be speaking into the system to be
comfortable. comfortable. comfortable.
A recommended height is shown. A recommended height is shown. A recommended height is shown.
3 3 3
Lift off the outer cover of the entry Lift off the outer cover of the entry Lift off the outer cover of the entry
panel. panel. panel.
6
In the case of an uneven wall, the In the case of an uneven wall, the In the case of an uneven wall, the
tabs may be cut as shown to allow tabs may be cut as shown to allow tabs may be cut as shown to allow
the base to 'sit' on the wall without the base to 'sit' on the wall without the base to 'sit' on the wall without
Rocking. Rocking. Rocking.
Page 8 - Polophone Intercom
1B 1B 1B
Gooseneck Installation Gooseneck Installation Gooseneck Installation
Alternatively mount the entry panel Alternatively mount the entry panel Alternatively mount the entry panel
onto a gooseneck ensuring that: onto a gooseneck ensuring that: onto a gooseneck ensuring that:
The entry panel does not protrude The entry panel does not protrude The entry panel does not protrude
too far into the driveway. too far into the driveway. too far into the driveway.
The entry panel is not set too far back The entry panel is not set too far back The entry panel is not set too far back
and can be easily accessed from a and can be easily accessed from a and can be easily accessed from a
vehicle. vehicle. vehicle.
The height allows speaking into the The height allows speaking into the The height allows speaking into the
system to be comfortable. system to be comfortable. system to be comfortable.
4 4 4
Insert screwdriver as shown and un- Insert screwdriver as shown and un- Insert screwdriver as shown and un-
clip the electronic module from base. clip the electronic module from base. clip the electronic module from base.
7
100mm 100mm 100mm 100mm 100mm 100mm
Hold the entry panel base against the
wall at the required height ensuring
that it is vertical.
Mark the location of the mounting
holes.
Using a 6mm masonry bit, drill holes
into the wall for the rawlplugs
provided in the kit.
2
Dimensions of the entry panel base Dimensions of the entry panel base Dimensions of the entry panel base
and mounting holes relative to the and mounting holes relative to the and mounting holes relative to the
entry panel cover. entry panel cover. entry panel cover.
5 5 5
Lift electronic module off base. Lift electronic module off base. Lift electronic module off base.
If the cable is being routed into the unit
from a concealed conduit behind the
base, knock out one of the cable entry
holes provided in the base and feed
through the cable. Ensure that at least
A A A
100mm of cable extends out of the
wall.
Fit sealing washer (A) onto top
mounting screw before installing.
74mm 74mm