Videofied IMD 200 Product Installation Sheet

P R O D U C T
Product Summary
The Motion Detector IMD 200/601/701 is a
wireless, indoor motion detector designed for
use in a Videofied security system. The motion
detector includes the following features:
> Lithium batteries for long life
> Standard motion coverage lens (30 ft./9 m
distance)
> Dual tamper function provides detection of
both wall and cover tamper.
> Transmits check-in/status signal every 8 minutes
Flat Wall Mounting
Flat Wall
Mounting
Holes
Corner Mounting Holes
Note: Only two screws are
used for corner mounting (Left
or Right)
Indoor Motion Detector IMD 200/601/701
I N S T A L L A T I O N
Corner Mounting
www.videofied.com
S H E E T
Installation Guidelines
For an easier installation, programming and RF testing should be
done to check for good communication between the control panel
and all system devices before mounting.
Install the detector and other system devices in the following order:
>
Programming / RF Testing: Program detector and all other devices
into the control panel and test RF communication at each intended
device location to the control panel.
>
Mounting: Mount detector at the tested location.
Mounting Rules
>
Use proper tools and hardware.
>
Mount indoors in a temperature controlled environment.
>
Mount detector 2.1 to 2.3 m (6.9 to 7.5 ft.) from the floor.
>
Respect Top and Bottom side of the Motion Viewer
>
When possible, mount in a wall corner in order to aim at a complete
room
>
Mount detector on an outside wall, aimed at area to protect.
>
Do not aim detector at windows, especially those that let in direct
sunlight, or at heat sources such as lamps, fireplaces, radiators,
and heating vents.
>
Do not aim detector at moving objects such as curtains, fans or
animals.
>
Do not cover the Fresnel lens
Doc. - Ref. 214-IMD
Version : June 2013