General Information; General Information; Special Tools; Special Tools - Toro Pro Sweep 07066 Service Manual

General Information

Operator's Manual

The Operator's Manual provides information regarding
the operation, general maintenance and maintenance
intervals for your Pro Sweep machine. Refer to that pub-
lication for additional information when servicing the
machine.

Electrical Diagrams

The electrical schematic, circuit drawings and wire har-
ness drawings for the Pro Sweep are located in Chapter
6 -- Electrical Diagrams.

Special Tools

Multimeter
The multimeter can test electrical components and cir-
cuits for current (amps), resistance (ohms) or voltage.
Obtain this tool locally.
NOTE: Toro recommends the use of a DIGITAL Volt--
Ohm--Amp multimeter when testing electrical circuits.
The high impedance (internal resistance) of a digital me-
ter in the voltage mode will make sure that excess cur-
rent is not allowed through the meter. This excess
current can cause damage to circuits not designed to
carry it.
Figure 1
Page 4 - - 2
Electrical System Pro Sweep