Linhai Landboss LH800U-2D Owner's/Operator's Manual page 87

LH800U-2D(L)/LH800U-2D(R)
14. BATTERY
Battery Installation and Connections
WARNING
To avoid the possibility of explosion, always connect battery cables in
the order specified. Red (positive) cable first; black (negative) cable last.
An exploding battery can cause serious injury or death.
WARNING
Battery terminals and connections should be kept free of corrosion.
If cleaning is necessary, remove the corrosion with a stiff wire brush.
Wash with a solution of one tablespoon baking soda and one cup water.
Rinse well with tap water and dry off with clean rags. Coat the terminals
with dialectic grease or petroleum jelly. Be careful not to allow cleaning
solution or tap water into the battery.
8. Set the battery in its holder.
9. First connect and tighten the red (positive) cable.
10. Second connect and tighten the black (negative) cable.
11. Reinstall battery cover and attach the hold down strap.
12. Verify that cables are properly routed.
NOTE:
When you UTV is placed in storage for one months or more, the
battery should be removed, charged to proper level, and stored in a
cool dry place.
Before reusing, take the battery to your dealer for testing and
recharging.
Power plug leads may need to be bent down so that battery cover may
be installed.
When installing a new battery, make certain it is fully charged prior
to it is initial use. Using a new battery that has not been fully charged
can damage the battery resulting in a shorter life of the battery, It can
also hinder vehicle performance.
OWNER'S/OPERATOR'S MANUAL
14 - 2
14.0