During Storage - Linhai Landboss LH800U-2D Owner's/Operator's Manual

OWNER'S/OPERATOR'S MANUAL
LH800U-2D(L)/LH800U-2D(R) 14.0
16. MAINTENANCE
5. Examine the coolant condition. Replace if necessary.
6. Examine all fluid levels. Top up if necessary.
PUT THE MACHINE INTO STORAGE
1. Park the machine on level, solid ground. Park the machine in a
position where the machine is easy to tow (in case the machine does
not start at the end of the storage period).
Place suitable timbers under the machine to eliminate direct contact
with the ground.
2. Retract all rams and lower the attachments to the ground, if
applicable.
3. Vent the hydraulic system, if applicable.
4. Remove the starter key.
5. Apply a thin layer of grease or petroleum jelly to all exposed ram
piston rods, if applicable.
6. Remove the battery. Charge the battery.
Keep the battery in warm, dry conditions. Charge the battery
periodically.
7. If you keep the machine outdoors, cover the machine with tarpaulins
or plastic sheets.
8. Frequently turn the road wheels to prevent distortion of the tyre-ply.

DURING STORAGE

Operate the machine functions each week to prevent a build up of rust
in the engine and hydraulic circuits, and to minimise deterioration of the
hydraulic seals.
1. Clean the machine to remove all unwanted material and corrosives.
Remove the grease or petroleum jelly from the ram piston rods, if
applicable.
2. Install a charged battery.
3. Start the engine.
4. Operate the hydraulic controls, if applicable.
Make sure that the hydraulic functions operate correctly.
5. Prepare the machine for storage. Refer to Put the Machine into
Storage.
TAKE THE MACHINE OUT OF STORAGE
1 Examine the coolant condition. Replace If necessary.
2 Examine all fluid levels. Top up if necessary.
16 - 24