Panasonic TX-51P100X Service Manual page 28

30. Select the "G-POINT CURSOR" mode by pushing
"TV/AV" button on the remote control.
31. Use the Position Buttons to move the cursor to the
point where you wish to change the data (adjust-
ment lines). Then use the "SOUND MUTE [
change from "G-LINE CURSOR" to "G-LINE
DATA".
32. Use the Position Buttons to adjust each point so
that the Green Crosshatch Pattern is aligned with
the vertical and horizontal lines of the Conver-
gence Adjustment Sheet.
33. Push the "SOUND MUTE [
POINT DATA" to "G-POINT CURSOR".
34. Repeat step 31-33 to adjust all of adjustment
points.
G-POINT
CURSOR
[ ]
Position
Buttons
Green crosshatch pattern
Convergence Adj. sheet lines
(Adjust points = All cross points)
35. Adjust the LINE, EASY2 and POINT DATA again
viewing all over the screen.
If need the adjustment at the around of screen,
select the "PERI-CURSOR" and adjust it.
36. To store the data after the Green Convergence
Adjustment has been completed, push the "MAIN
MENU" button and then push the "N" button (push-
ing the "N" button will store the data in the
2
E PROM).
]" and switch from "G-
G-POINT
DATA
37. Remove the Convergence Adjustment Sheet from
the screen.
<Red Convergence Adjustment>
]" to
38. Push the "PIP" button twice and change to the Red
Adjustment of Yellow Colour.
39. Repeat the same steps described for the Green
Conv.Adj. in 20~35 to perform the Red Conver-
gence Adjustment.
40. To store the data after the Red Convergence
Adjustment has been completed, push the "MAIN
MENU" button and then the "N" button.
<Blue Convergence Adjustment>
41. Push the "PIP" button twice and change to the
Blue Adjustment of cyan Colour.
42. Repeat the same steps described for the Green
Conv.Adj. in 20~35 to perform the Blue Conver-
gence Adjustment.
43. To store the data after the Blue Convergence
Adjustment has been completed, push the "MAIN
MENU" button and then push the "N" button.
44. To switch from the Convergence Adjustment Mode
to the Service Mode, press the Power button and
then push the "N" button.
Repeat the same adjustment after inputting the
60Hz (NTSC) signal.
IN DIGITAL CONVERGENCE ADJ.MODE
EXIT
ADJ.COLOUR
CLEAR
LSI MODE
COPY
STORE
DECISION
- 28 -
KEY OF REMOTE
SURROUND
TV−AV
ADJ.MODE
CURSOR/DATA
1 2 3
4 5 6
7 8 9
0
CROSSHATCH
COLOUR
D.PNR CH SEARCH STILL PIP
SUPER IN PAUSE
P. AI STROBE CHANGE PIP ACTION
OSD ON/OFF
VCR/LD/DVD
CROSSHATCH
DENSITY
VCR LD/DVD
DISE SIDE
A B
MAIN MENU
SKIP
N
RGB
SKIP
/ TV/TEXT INDEX HOLD
TIME
F.P. REVEAL F/T/B
TEXT
?
R G Y B