Panasonic TX-51P100X Service Manual page 10

Disassembly For CRT Removal
To facilitate CRT replacement, the complete CRT
mounting chassis does not need to be removed.
1. Remove the Screen Frame Ass'y, Decorative
Panel and the Bottom Rear Cover Ass'y. ( See Dis-
assemble for Service ).
2. From the Rear side, remove the defective CRT's
anode lead from the Flyback Transformer block
that is mounted secured to the Main chassis E-
Board.
3. Grasp the anode lead protective cap body inside,
and rotate 1/4 turn counter clockwise and pull
anode lead sleeve out of the distributor.
4. Discharge anode lead to CRT chassis metal
frame.
Anode lead
FBT
5. Unplug the defective CRT Dag ( GND ), from the
CRT Board, LBGND for LB, LGGND for LG,
LRGND for LR.
6. Remove lead wires ( DY, VM coil ) and anode lead
wire from holders as necessary.
7. Remove the CRT Board from the defective CRT
neck.
8. Loosen a screw that secured the VM Coil and
remove SR/SG/SB Board from CRT neck.
- 10 -