Reset The Wdmx; Battery Status Of The Led; Setup Temp - Ignition LED Accu PAR 64 Floor RGB+W User Manual

Here you can switch of the wireless DMX. Now the Accu Par needs no extra power for WDMX any
more

2.7.1. 11. Reset the WDMX

Push DOWN to reset the WDMX an cut all

2.8. Battery status of the LED

In this menu the LCD shows that the status LED for the battery 's power is turned to "on".
Push down to turn off this led to safe power.
13. Master Mode On/ Off
Here you can control if the Par is acting as a master, or whether it should not send signals.
14. Key Lock
Here you can set up if the Par shall lock the buttons
OFF means the buttons are not locked at any time
30s means, that if you don´t push a button in 30 sec. the buttons are locked.
You can unlock the Par by pushing the UP and DOWN button for 3sec.

15. SETUP TEMP

connections
This Display shows you the temperature from the LED board in°C.
If the measured temperature is above 70 °C the output power is
reduced slowly up to 30%, until the temperature falls back to 70 °
C, or below, in order not to endanger the life of the LED's.
.
8 / 16
L E D A C C U P A R