Ford TOURNEO CONNECT 2015 Owner's Manual page 214

You can use the button to return to radio
reception when you have been listening to
another source.
Alternatively, press the left arrow button
to display the available frequency bands.
Scroll to the required frequency band and
press OK.
Station Tuning Control
Seek Tuning
Select a frequency band and briefly press
the seek up or seek down button. Seek
tuning will stop at the first radio station it
locates.
Manual Tuning
1. Press function button 2.
2. Use the left and right arrow buttons to
tune down or up the frequency band in
small increments or press and hold to
increment quickly, until you find a
station you want to listen to.
3. Press OK to continue listening to a
station.
Scan Tuning
Scan allows you to listen to a few seconds
of each station detected.
1. Press function button 3.
2. Use the seek buttons to scan up or
down the selected frequency band.
3. Press function button 3 again or OK to
continue listening to a station.
Station Preset Buttons
This feature allows you to store your
favorite stations, they can be recalled by
selecting the appropriate frequency band
and pressing one of the preset buttons.
1. Select a frequency band.
2. Tune to the station required.
Tourneo Connect (CHC) Vehicles Built From: 10-03-2014, Vehicles Built Up To: 31-12-2014, Long Wheelbase Kombi/Short Wheelbase Kombi, Base/Base High Payload/Titanium/Titanium High Payl
Audio System
3. Press and hold one of the preset
buttons. A progress bar and message
will appear. When the progress bar
completes the station has been stored.
The audio unit will also mute
momentarily as confirmation.
You can repeat this on each frequency
band and for each preset button.
Note: When you drive to another part of the
country, stations that broadcast on
alternative frequencies, and are stored on
preset buttons, may be updated with the
correct frequency and station name for that
area.
Autostore Control
Note: This will store up to a maximum of
the 10 strongest signals available, either
from the AM or the FM frequency band, and
overwrite the previously stored stations. You
can also store stations manually in the same
way as other frequency bands.
Note: You must select either FM AST or
AM AST to use this function.
• Press the MENU button, select audio
mode then press and hold the RADIO
button.
• When the search is complete, sound is
restored and the strongest signals are
stored on the autostore presets.
Traffic Information Control
Many stations that broadcast on the FM
frequency band have a TP code to signify
that they carry traffic program information.
Turning Traffic Announcements On and
Off
Before you can receive traffic
announcements, you must press either the
TA or TRAFFIC button. A TA display will
appear to show the feature is switched on.
212