Driving Aids; Speed Limiter - Ford TOURNEO CONNECT 2015 Owner's Manual

SPEED LIMITER

Principle of Operation
WARNING
When you are going downhill, your
vehicle speed may increase above
the set speed. The system will not
apply the brakes but a warning will be
given.
The system allows you to set a speed, to
which your vehicle then becomes limited.
The set speed will become the effective
maximum speed of your vehicle, but with
the option to temporarily exceed this limit
if required.
Using the System
The system is operated by adjustment
controls mounted on the steering
wheel.
A Set speed increase
B On and off
C Set speed decrease
D Cancel and resume
Tourneo Connect (CHC) Vehicles Built From: 10-03-2014, Vehicles Built Up To: 31-12-2014, Long Wheelbase Kombi/Short Wheelbase Kombi, Base/Base High Payload/Titanium/Titanium High Payl

Driving Aids

Note: The set speed limit can be
intentionally exceeded for a short period of
time if required, for example when
overtaking.
Switching the System On and Off
Press switch B. The information display
will prompt you to set a speed.
Setting the Speed Limit
Use the cruise control switches to alter the
maximum speed setting.
Press switch A or C to select your desired
speed limit. The speed is displayed in the
information display and stored as the set
speed.
Pull switch D to cancel the limiter and
place it in standby mode. The information
display will confirm this has been turned
off by showing the set speed crossed out.
Pull switch D again to resume the limiter.
The information display will confirm this
has been turned on by showing the set
speed again.
Intentionally Exceeding the Set Speed
Limit
Depress the accelerator fully to temporarily
turn the system off, this will be indicated
in the information Display. The system will
turn on once your vehicle speed drops
below the set speed.
System Warnings
If you exceed the set speed, a warning will
flash in the information display and you
will hear a warning chime.
130