Haier HW80-B14266A User Manual page 53

Installation
3. Drain hose to waste water connection
Use the drain hose bracket to keep drain hose end
retained.
Fix the bracket sufficiently to avoid dropping down due
to operational movements.
Warning!
The drain hose should not be submerged in water and should be
securely fixed and leak-free. If the drain hose is placed on the
ground or if the pipe is at a height of less than 80cm, the washing
machine will continuously drain while being filled (self-siphoning).
Drain hose is not to be extended. If necessary contact after sales
service.
Inlet hose - Aqua control System
The Aqua Stop inlet hose is an important element for
safety and over all control. Its valves are controlling water
supply and will interrupt it if the hose is leaking
1. Connect the nut on the inlet hose to the connector
on the water valve.
2. Apply inlet hose to a water tap.
Do not twist, kink or jam the inlet hose.
Warning!
Appliance is only qualified for cold water supply!
Use the hose-set supplied with the appliance.
Old hose-sets should not be reused.
Do not connect to hot water.
Power supply connection
Before each connection check if:
▶
the power supply, the socket and fusing is
appropriate to the rating plate.
▶
the power socket is earthed and no multi-plug or
extension.is used.
▶
Only U
K: The UK plug meets BS1363A standard
General information and tips:
After each installation or longer down time run at first
programme "Self Clean" with no load and added deter-
gent in washing agent compartment (2) to remove
possibly corruptive residues.
25
1.
2.