After Washing - Haier HW80-B14266A User Manual

16
Function
Selection Delay
Not applicable to serial numbers CEAAJVE0H00CPE6U0001 to CEAAJVE0H00CPE6U0075 and CEAAJVE0H00CPE6P0001
Environmentally responsible use
▶
To achieve best use of energy, water, detergent and time you should use the
recommended maximum load size
▶
Do not overload (hand width clearance above laundry).
▶
Apply exact dosages of each washing agent.
▶
Choose the lowest adequate washing temperature - modern detergents are
efficiently cleaning below 60°C.
▶
Raise default settings only due to heavy staining.
▶
Select max. spinning speed if a domestic dryer is used.
Interrupt - cancel wash programme
To interrupt a running programme press gently "Start/
Pause".
Programme run-time is flashing. Press it again to resume
operation.
To cancel a running programme and all its individual set-
tings activate "Start/Pause" and then for about 3 seconds
"On/Off".

After washing

At programme cycle end
machine will shut off automatically.
Remove laundry as soon as possible to go easy on it and
to prevent more wrinkling.
Turn off the water supply and unplug the power cord.
Open the door to prevent formation of moisture and
odours. Let it open while not used.
Standby-mode
The switched on washing machine will go into standby-
mode if it will not be activated within 2 minutes before
starting the program or at the end of program. To inter-
rupt the standby-mode push one key. During standby-
mode the Start/Pause button shine all the time.
Activate or deactivate the buzzer
1. Switch on the appliance.
2. Select the "Spin/drain" programme.
3. Press the "function" and "selection" button (also as
"speed up") at the same timefor 3 seconds. "BEEP
OFF" will be dis
For activating the buzzer please press these two buttons
at the same time again. "BEEP ON" will be displayed.
End" is displayed, afterwards
"
played and the buzzer will be deactivated.
Dayly use
-