Desa CVDA24M Owner's Manual page 9

12. Replace brass plug into regulator.
13. Using two screws removed in step 2, page
8, replace valve cover.
14. Gently loosen and remove the pilot line
connection from the pilot bracket (see
Figure 11).
15. Replace injector with propane/LP injector
with red stripe.
16. Replace and tighten pilot line to bracket.
17. Using screws removed in step 2, page 8,
reattach pilot bracket to valve cover.
18. Continue with step 1 under Hearth Pan
Installation, page 7.
Pilot
Bracket
Pilot Injector
Figure 11 - Installing Propane/LP Pilot
TESTING BURNER FOR LEAKS
1. Generously apply soapy solution to all
connections.
WARNING: Never check for
gas leaks with open flame.
2. Light burner with the shutoff valve no
more than half open and holding a match
slightly in front of the pan (see Lighting
Instructions, page 11).
3. Inspect all connections for bubbles,
raw gas odor, or flame from any area
other than the burner (leaks). If leaks
are detected, shut off gas valve imme-
diately. Tighten, or reassemble loose
connection(s) using pipe joint compound
until burner system is leak free.
4. When burner is tested and leak free,
observe the individual tongues of flame
on the burner.
Note: The burner design includes more
ports on the outside of the bar. Make
sure that all ports are clear and produc-
ing flame evenly across the burner. If
any ports appear blocked, clear them by
removing the burner manifold and ream-
ing the ports with a modified paper clip or
other suitable tool.
901268-01H
INSTALLATION
Pilot Adjustment
Screw
Orifice
www.desatech.com
Continued
5. When finished testing, turn gas shutoff
valve OFF to extinguish all flames.
ADDING PAN MATERIAL
1. Open bag of ash bed material (vermiculite)
and spread it evenly across burner pan to
the top. You may overflow front and sides
of pan to cover entire pan. Do not cover
valve or inlet fitting.
2. Open glowing embers and evenly cover
ash bed material (vermiculite) in the
burner pan.
INSTALLING GRATE AND LOGS
1. Place grate over burner pan where the
two outer horizontal supports on the grate
fit into the two pan positioning notches in
the rear vertical edge of pan.
2. Slide two rear log grate steps over the
two outer horizontal supports on grate as
shown in Figure 12.
3. Place back log on grate onto grate steps
(see Figure 13, page 10).
4. Place front log(s) on grate and slide for-
ward against front bars on the grate (see
Figure 13, page 10).
5. Place smaller top logs onto bottom logs (see
Figure 14, page 10). Leave as much open
space between logs as possible to minimize
flame impingement and sooting.
Note: Logs may chip if they are handled
roughly or if hit together while being
placed.
Grate
Figure 12 - Installing Grate (Pan Material
Grate Steps
Not Shown)
9