Tools Required For Assembly; Assembly Instructions - PaceMaster Pro-Plus Owner's Manual

• The PaceMaster is packed in five pieces: the main unit, the handlebar, the siderails, the motor cover, and the hardware package which contains
this manual. Once you have removed all of the pieces from the box, inspection of the treadmill should be made to check for any concealed
damage that may have occurred during shipment.
• Before assembling your treadmill, open the hardware package and verify that you have the following items.
2 -------- 1/4 - 20 x 4" black carriage bolt
4 -------- 1/4-20 x 3" silver carriage bolt
6 -------- 1/4-20 kep nuts
3 -------- #8 x 1/2 black sheet metal screws
2 -------- black siderail brackets
2 -------- 1" OD fender washers
1 -------- 3/16" allen wrench
1 -------- magnetic key with garment clip
If any parts are missing please contact your authorized PaceMaster dealer.
• 3/16" allen wrench (supplied)
• 7/16 combination wrench
• Phillips head screwdriver
CAUTION: Be extremely careful not to damage the speed
sensor (figure 2) while installing the handlebar or motor cover.
1. Carefully place the bottom of the handlebar on the frame
so the two holes in the plate at the bottom of the handlebar
line up with the two holes in the frame. Insert two 3" carriage
bolts #1 through the handlebar and the frame and install two
kep nuts #2 to keep the handlebar in place. Follow the same
procedure for the other side of the handlebar. Do not tighten
any nuts until both sides are bolted in place.
2. With the handlebar in place plug the wire harness #3 into
the socket #4 on the power supply board (figure 2).
3. Take one of the siderails #7 (figure 3) and slide the end
with the grip over the end of the steel tube protruding
from the control panel. Slide the siderail on until the
grip touches the control panel.

Tools Required for Assembly

Assembly Instructions

Figure 1
4