Table of Contents
Advertisement
User Manual
7.0 DISPLAY PANEL MODES
7.1 Introduction
The LCD display panel has two basic modes of operation:
•
Measure Mode
•
Menu Mode
When the thermometer is switched on, an introduction screen is displayed.
This screen times-out automatically and is replaced by the Measure Mode
display.
To access the Menu Mode from the Measure Mode, press the
select) key on the keypad.
7.2 Measure Mode
When the unit is in Measure Mode, the display indicates the Peak,
Continuous, Average, and Valley temperature values simultaneously.
Scroll using the
measurement type. This measurement type is then displayed in the viewfinder.
On the side LCD display panel, the selected measurement type is displayed
larger and bolder than the three non-selected measurement types. Note that
the thermometer measures in all four measurement types continuously.
Peak reading
Continuous
reading
Average reading
Valley reading
Page 14
and
keys to select and highlight the required
Fig. 17 Typical 'Measure Mode' display
Wahl DHS520
(Enter/
315017
Advertisement
Table of Contents
