Miele PT 8257 WP Operating And Installation Instructions page 25

Power failure
y
Program stop.
Press Start.
^ Press "START" to continue the program.
Heating system fault
§
Contact Technical Service.
if restart w/o success.
^ Contact Technical Service.
Card fault
§
Reinsert card correctly in card
reader.
^ Insert the card properly into the card reader.
Escaping condensation
If condensation escapes from an undesired place in
the system, check if the collection basin is resting
f
correctly in the drain and the drain is free of soiling.
These parts are accessible via the rear maintenance
cover in the floor area.
Decreasing system efficiency
This system is designed to operate at a room
temperature of up to 113°F (45 °C). Occasional
operation above this temperature should not cause
any problems. However, if temperatures continuously
exceed 113°F (45 °C), an external cool air supply
f
must be ensured. You can additionally reduce strain
on the system by keeping the heat exchangers free of
lint accumulation and other soiling. This reduces wear
and tear, thereby increasing the life of your system.
Check the system for the following should it lose
efficiency over time and require clearly longer drying
times:
– Soiling of the dryer lint filter
A
– Soiling of the heat exchangers in the heat pump
– Tightness of the connection between the dryer and
heat pump
– Heat pump air intake and and exhaust vent
– External fresh air and ventilation ducting is
recommended if room temperature frequently
exceeds 113°F (45 °C)..
After-sales service
^ In the event of a fault which you cannot correct
yourself, please contact Technical Service.
^ When contacting Technical Service please quote
the model, serial number (SN) and part number
(M.-Nr.) of the machine.
They can be found on the data plate located at the
top of the door opening (when drum door is open) or
on the back of the machine at the top.
^ When contacting Technical Service report the fault
in the display.
Only use original Miele spare parts when performing
maintenance or repairs on this machine. When
ordering please quote the model, serial number (SN)
and part number (M.-Nr.) of the machine.
Frequently asked questions
25