Advertisement
If you wish to reset your GPMX-16 to factory defaults, you can do so by turning the power on whilst
holding down all three push buttons (mode, dec & inc). This will return the GPMX-16 to it's default
settings.
'Fd' (factory defaults) will momentarily be displayed when this has been done.
DISPLAYING THE FIRMWARE VERSION NUMBER
Power the unit on while holding the 'INC' button pressed. While the INC button is held, the firmware
revision number [1xxx] will be displayed in pairs – two dashes then digits 1 & 2 then digits 3 & 4
repeated. Releasing the INC button will revert to the normal operational mode.
Power Input
Power consumption
MIDI
Inputs
Outputs
Display
Weight
Dimensions
Non-volatile memory
The GPMX-16 comes with a 12 month (from purchase date) back to base warranty, (i.e. customer
must arrange and pay for carriage to and from Kenton Electronics).
Brookfarm House, 1 Station Road, South Wimbledon, London, SW19 2LP, UK
Tel: +44 (0)20 8544 9200
sales@kenton.co.uk
firmware rev# 1001
FACTORY DEFAULTS
SPECIFICATIONS
9V DC – switch mode mains adaptor supplied
200mA max, 2.1mm plug (centre positive)
In, Out1 & Out2 (out1 & out2 give the same data out)
16 GPI – 8 on each of 2 x 9 pin D connectors – pin 9 common ground
16 GPO – 8 on each of 2 x 9 pin D connectors – pin 9 common
3 x 7 segment display
1Kg including PSU
190 x 110 x 45 mm
EEPROM (no back-up battery required)
WARRANTY
e. & o. e. © 30
6
Fax: +44 (0)20 8544 9300
www.kenton.co.uk
th
April 2014
Advertisement
