Carrier Infinity SYSTXCCUIZ01 Installation And Start-Up Instructions Manual page 3

Fig. 2—Infinity Zone Control
Fig. 3—Recessed Mount Backplate
Fig. 4—Surface Mount Backplate
DECORATIVE BACKPLATE — Supplied is a thin decorative
backplate (see Fig. 5), to hide any marks/screw holes left from the
previous thermostat. This decorative backplate (or beauty ring) can
be used in either the recess or surface mount installation by
snapping it onto back of recessed mount backplate or surface
mount backplate before securing to wall. See Fig. 8 and 9 for a
larger decorative backplate P/N SYSTXXOLBP01 (5.75" wide X
6" tall), which can be ordered separately.
Fig. 5—Thin Decorative Backplate
A03185
Fig. 6—Recessed Mount Assembly
A03186
Fig. 7—Surface Mount Assembly
A03187
STEP 3 — INSTALLING INFINITY ZONE CONTROL™
ELECTRICAL SHOCK HAZARD
Failure to follow this warning could result in personal injury
or death.
Before installing Infinity Zone Control™, turn off all power
to equipment. There may be more than one power source to
disconnect.
1. Turn off all power to equipment.
2. If an existing User Interface or control is being replaced:
a. Remove existing control from wall.
b. Disconnect wires from existing control.
3
A04017
Recessed terminal
1
block in wall 1 / ˝
2
wide by 2 1 / ˝ high
8
Recessed Mount
Interlocking Tabs (4)
A03190
Surface Mount
Backplate to wall
Interlocking Tabs (4)
A03191