Windscreen; To Remove The Windscreen - Triumph 2010 Rocket III Handbook

Caution
To prevent damage to the seat or seat
cover, care must be taken not to drop the
seat. Do not lean the seat against the
motorcycle or any surface which may
damage the seat or seat cover. Instead,
place the seat, with the seat cover facing
upwards, on a clean, flat surface which is
covered with a soft cloth.
Do not place any item on the seat which
may cause damage or staining to the seat
cover.
To refit the seat, engage the seat's tongue
under the fuel tank, fit and tighten the side
fixings to 15 Nm.
Fit the rear fixing, with the reflector, and
tighten to 9 Nm.
Warning
To prevent detachment of the seat during
riding, after fitting always grasp the seat
and pull firmly upwards. A loose or
detached seat could cause
motorcycle control and an accident.
General Information

Windscreen

Note:
• The windscreen fitted to this
motorcycle
without the use of tools.

To remove the windscreen

2
5
cenp
1. Upper mounting
2. Lock handle
3. Lock
4. Lower mounting
loss of
5. Windscreen
To remove the windscreen, stand astride the
front wheel. Pull the lock handles towards the
windscreen to release the locks from the
upper mountings. For complete removal
from the motorcycle, lift the windscreen up
until it is released from the upper and lower
mountings.
can be removed
1
3
4
33