Biketronics BT1000 Installation Instructions Manual page 4

• Remove outer fairing (Remove fairing bolts and disconnect headlight
wire connector).
• Remove Harley glove box or stock radio from fairing.
Retain the 4 Allen-head bolts.
• 1996-1997 only: Remove cradle used to support Harley radio.
• 1988-1997: Both radio memory and radio power fuses must
be changed to a 10 amp rating for radio to operate. Do not
exceed 10 amp rating.
Step 1
Radio Cage:
Remove & Discard
Disconnect battery
before proceeding!
Failure to do so
will cause a short
to ground and is
not covered under
warranty!
Preparation of Fairing
Remove Cage – Position Bezel Plate
Black Bezel Plate
Remove and discard radio cage.
Slide the black bezel plate on from
the rear, with the textured side
facing front of radio. Leave trim
ring on.
4
Disconnect battery
before proceeding!
Radio Trim Ring