Automatic Volume Control (Avc) - Biketronics BT1000 Installation Instructions Manual

This procedure should not be necessary with new modules. All new
modules come pre-programmed. We recommend testing the stock
settings before changing the AVC.
To setup the AVC, please note the following:
• AVC information WILL NOT display on radio face! If your radio face
changes at any point, turn off the bike and start over.
• The only method to verify successful AVC programming is to ride the
bike and verify that radio volume varies with speed.
• You should count out the seconds or use a watch to determine the
correct amount of time has passed, and then quickly go into step #2.
• There is a video of the procedure available at biketronics.com
10 pushes = fastest gain
1 push = slowest gain
0 pushes = AVC off
To begin, turn on the radio – if the display changes at any point during
this procedure, turn off the bike and start over.
Step #1
Step #2
Step #3
Step #4
Step #1
Step #2
Step #3
Step #4

Automatic Volume Control (AVC)

1996 - Present HARLEY DAVIDSON
LEFT BUTTON - PUSH IN and HOLD for 10
SECONDS, then release to enter programming mode
LEFT BUTTON - PUSH UP and Release 2-10 times.
This step will time out after two seconds following the
last push
DO NOT operate controls for 10 seconds to allow
programming to reset
Ride bike to verify AVC program. Volume should
change with speed.
1988-1995 HARLEY DAVIDSON
LEFT BUTTON - PUSH IN and HOLD for 10
SECONDS, then release to enter programming mode
LEFT BUTTON - PUSH RIGHT and Release 2-10
times.
This step will time out after two seconds following the
last push
DO NOT operate controls for 10 seconds to allow
programming to reset
Ride bike to verify AVC program. Volume should
change with speed.
If you do not push anything within two
seconds of releasing after Step #1,
then the module will read that as 0
pushes and will turn the AVC off!
13