Error Messages On Remote Entry Failure; Error Messages Generated During Remote Entry - Panasonic DP-C305 Service Manual

10.2. Error Messages Generated during Remote Entry

If errors occur during remote entry in the address book or program dialing, error messages are Emailed
from this machine to the sending station.
10.2.1. Error Messages
If errors occur during remote entry in the address book or program dialing, the following error messages are
Emailed from this machine to the sending station:
No. Error message
1 554 Data transfer error (broken header)
2 554 Data transfer error (broken data)
3 554 Data transfer error (Fax module)
4 554 MIME attachment not supported
(message/file)
5 554 MIME format not supported
6 554 Fax relay permission denied
7 554 Relay address unknown
8 554 Memory fully (Fax module)
9 554 Data transfer error

10.2.2. Error Messages on Remote Entry Failure

If errors occur during remote entry in the address book or program dialing, the following error messages are
Emailed from this machine to the sending station:
No. Error message
1 There is an error in the @command block.
2 The @begin command is missing.
3 There is an error in the @begin block.
4 There is an error in the @system block.
5 There is an error in the @sender block.
6 There is an error in the @domain block.
Ver. 1.1
Probable cause and recommended action
Process was aborted due to an error occurring while encoding
the header or sub-header. Resend.
Process was aborted due to an error occurring while encoding
data. Resend.
A data transfer error occurred on the Fax module while
communicating with the LAN module. Resend.
An unsupported MIME file attachment was transmitted. Resend
the document with text data alone.
An unsupported MIME type was transmitted. Resend the
document with text data alone.
The name of the domain requesting relay is not preprogrammed.
The telephone number of the final receiving station requesting
relay is unknown.
Fax memory is full. Resend later.
This error is not on the list. Resend later.
Probable cause and recommended action
The block end command "@end" is missing in the "@command "
block. Resend with the addition of an "@end " command.
The block start command "@begin" is missing in the "@begin"
block. Resend with the addition of an "@begin" command.
The block end command "@end" is missing in the "@begin" block.
Resend with the addition of an "@end " command.
The block end command "@end" is missing in the "@system "
block.
Resend with the addition of an "@end " command.
The block end command "@end" is missing in the "@sender "
block.
Resend with the addition of an "@end " command.
The block end command "@end" is missing in the "@domain"
block. Resend with the addition of an "@end " command.
747
DP-C405/C305/C265
FEB 2008