Kodak Ngenuity 9000 Series User Maintenance Manual page 11

6-10
11. Exit sensor: The exit sensor is located on the transport toward the
back of the scanner. Clean the exit sensor by placing the brush end
of the blower brush into the exit sensor area and squeeze the
blower brush several times.
Exit sensor
12. When all sensors are clean, close the scanner cover and reset the
maintenance reminder by clicking on the Clean Optics link on the
Maintenance monitor.
13. Click Reset on the dialog box to confirm the optics have been
cleaned. The reminder will be reset for the next required
maintenance session.
A-61662 October 2011