Tip-Over Switch - Hunter HFR15D-E Owner's Manual

After the display has shown "12", pressing the Timer Button
one more time will reset the heater to run continuously. The heater
will turn off when the set time has elapsed. The unit can be turned
back on by pressing the Power Button .
Automatic Temperature Control
1. To set the room at a specific temperature, press the or
buttons to the desired temperature. The heater is now in Auto
Temperature Mode .
2. The set temperature will show for several seconds and then the
display will return to indicate the current room temperature .
NOTE: The temperature display does not indicate the temperature
of the heated air being delivered by the heater.
3. When the room temperature reaches 2 degrees above the set
temperature, the heater will shut off. When the room temperature
reaches 2 degrees below the set temperature, the heater will turn
back on and continue to cycle off and on to maintain the set
temperature.
NOTE: It is normal for the fan to run for 30 seconds when the
heater shuts off after reaching the set temperature.
Remote Control (Figure 7)
1. The remote control uses two (2) "AA" batteries (not included)
for operation.
2. All the functions performed using the Remote Control work
identically to the Manual Controls.
Note: Change the batteries with new and same types if the
remote control does not operate well. Otherwise your remote
control may not operate properly. Remove the batteries out of the
remote control if you won't use the remote control for a long time.
Remaining batteries may damage your remote control.
Note: Do not mix old and new batteries. Do not mix alkaline,
standard (carbon-zinc), or rechargeable (nickel-cadmium)
batteries.
Figure 7
Battery Disposal - Please dispose of the used battery per
municipal or provincial law.

TIP-OVER SWITCH

This heater is equipped with a safety tip-over switch. This feature
cuts the main power to the heater if it gets knocked over. If the
heater does tip over, simply stand it upright in order to resume
operation.
THERMAL PROTECTION SYSTEM
This heater includes an Overheat Protection System that shuts the
unit off when the unit reaches excessively high temperature. If this
occurs, the heater can only resume its normal operation after
resetting it. To reset the heater:
1. Turn off the power switch in the rear of the unit.
2. Unplug the heater and wait 10 minutes for the unit to cool down.
3. After the 10 minutes, plug the unit in again and operate normally.
81609-01 R20150420
7