Dynacraft TALKING THOMAS TRIKE Manual page 9

STEP 2:
Attach one snap cap on either end
of the rear axle by carefully pounding it with
a hammer. Slide one plastic hub washer and
then one steel washer onto the axle towards the
snap cap. Next slide on one rear wheel followed
by one plastic spacer. Slide the axle assembly
through the rear deck of the tricycle. Next install
one plastic spacer, the other wheel, the other
steel washer, and the plastic hub washer onto
the axle. With the previously installed snap cap
on level ground use a hammer and carefully
pound the second snap cap onto the other end
of the rear axle.
STEP 3:
Insert the
rear axle into the slots
provided on the frame.
Make sure that the seat
mounts on the frame
are oriented facing
upwards. Insert the 2
carriage bolts into the 2
holes provided. Attach
nuts and washers and
tighten down securely
with a wrench.
STEP 4:
Insert the
fork into the bottom of
the frame. Slide a plastic
washer followed by a
locking ring over the top
of the fork. Insert the
handlebar into the fork.
Ensure that the minimum
insertion line is below the
locking ring. Make sure
the fork is flush with the
bottom of the frame and
tighten the locking ring with a wrench.
WARNING:
fork can result in the handlebars falling off and causing risk of injury.
Periodically check to ensure that the handlebar is securely attached.
Failure to properly install the handlebar to the
8