System Memory (Dram/Sdram & Sram); External Connectors - Asus C-PKND User Manual

III. INSTALLATION
Set the jumpers according to the internal speed of your processor, as follows:
CPU BUS (CPU Card BUS Ratio)
Internal Ratio JP1
266MHz 4.0x [short] [short] [open] [short]
233MHz 3.5x [open] [open] [short] [short]
CPU : BUS Frequency Ratio
You must also set the CPU External Frequency on the baseboard, as follows:
CPU External Clock (BUS) Frequency Selection
NOTE: Voltage Regulator Output Selection (VID) is not needed for the Pentium II
SEC slot because the Pentium II processor sends a VID signal directly to the CPU
card's power controller.
IMPORTANT: Before proceeding to the next step, set the other jumpers on your
baseboard. Refer to your baseboard's manual for the jumper settings.
2. System Memory (DRAM/SDRAM & SRAM)
Refer to your baseboard's documentation for procedures in installing memory modules.

3. External Connectors

Refer to your baseboard's documentation for instructions on connecting the ribbon
cables, cabinet wires, and power supply.
JP2 JP3 JP4
3.5X
1
2
3
66MHz 60MHz
ASUS C-PKND User's Manual
(CPU Ext. Freq.
Ext. on Baseboard)
Freq. JP3
66MHz [1-2]
66MHz [1-2]
4.0X
1
1
2 2
3 3
50MHz
JP2
[2-3]
[2-3]
11