Esc Instructions - Axial SCX10 Instruction Manual

ESC Instructions

Red
Black
White
Black
Connect the ESC wires to the motor.
Green LED
Red LED
2
1
ON
Apply and hold full throttle on the transmitter.
Turn on the ESC and it will emit a series of tones,
De Le De Le De Le, the red and green LED will flash
then only the green LED will remain blinking.
Apply throttle to make sure the motor
is going the direction you wanted.
Plug the ESC wire into the
throttle channel on the receiver.
Continue applying full throttle
De Le ...
Green LED
De Le De Le...
ESC blinks green and
emits De Le De Le De Le tone.
To reverse the direction of the motor,
switch the wires going to the motor.
Or reverse the transmitter throttle reverse switch.
If you're using NiMH or NiCd batteries turn " OFF " LiPo Cut- Off by visiting
the following link for Manually Programming the AE- 2 ESC : http: //www. axialracing. com/instructions .
Orange Black
Red
Apply full brake
Red LED
De Le De Le ...
ESC blinks red and
emits De Le De Le De Le tone.
8
3
OFF
2
TH-TRIM
1
Before plugging the battery into the ESC.
make sure your transmitter is on
and the throttle trim is set at zero,
and the ESC switch in the OFF position.
Set to neutral point
No LED
De Le De Le ...
ESC shows no LED's and
emits De Le De Le De Le tone.
The ESC will emit a final
short series of tones,
De Le De Le, confirming it
has been calibrated.
Do NOT reverse the battery wire connections!
Reversing the battery polarity will permanently
damage the ESC.