Advertisement

Quick Links

User Instructions
Cyrus Pre aCA7.5

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the aCA7.5 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Cyrus aCA7.5

  • Page 1 User Instructions Cyrus Pre aCA7.5...
  • Page 2 Cyrus Pre aCA7.5 Fig 4 1@ 1# LHC = RHC MC-BUS PREOUT2 PREOUT1 TAPE2 TAPE1 TAPE2 TAPE1 AUX2 AUX1 HEADPHONES OUTPUTS INPUTS RHC =+1dB MADE IN ENGLAND CAUTION:REPLACE WITH SAME TYPE FUSE. ATTENTION: UTILISER UN FUSIBLE DE RECHANGE DE MEME TYPE...
  • Page 3: Important! Read Before Operating This Equipment

    T200mAL 20mm retained for future reference. The mains supply requirement for your Pre aCA7.5 is marked on a label on FOLLOW INSTRUCTIONS: All operating and use instructions should be the rear panel. Before connecting, check that this voltage is the same as your followed.
  • Page 4: Preparations For Installation

    Pre aCA7.5 safely and correctly. Tape Input – TP1 IN h or TP2 IN g of the Pre aCA7.5 and a second cable from the Input or Record sockets of the tape deck to the Tape Record Output Preparations for Installation sockets of the Pre aCA7.5.
  • Page 5: Operation

    Repeat Steps 2 - 4 for each input to set the appropriate sensitivity level. red when in standby mode. The Pre aCA7.5 will switch from standby to on, Fig. 5(a) - 5(c) shows settings for Input Sensitivity levels set -2 dB, 0dB and when any input key h-1# is selected.
  • Page 6: Troubleshooting Guide

    User Instructions TROUBLESHOOTING GUIDE WARRANTY If your Pre aCA7.5 is not operating properly, disconnect the power and check carefully all connections. The warranty card enclosed should be completed by the Dealer and the If you are in any doubt, consult your dealer.

Table of Contents