Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Cyrus Pre XPd
Summary of Contents for Cyrus Pre XPd
- Page 2 IN-10 IN-11 MADE IN ENGLAND 1& 1$ 1# Fig 3 Fig 1 MC-BUS Cyrus amplifier MC-BUS out MC-BUS in Cyrus CD player MC-BUS out MC-BUS in Sample rate 44.1kHz Cyrus Tuner MC-BUS out MC-BUS in INPUT MUTE PHONES ZONE 2...
-
Page 3: Power Amplifier
Pre-amplifier Power amplifier 1 Right Left treble treble Right Left bass bass Power amplifier 2 Connecting a bi-amplified speaker system to a pre-amplifier Fig 5... -
Page 4: Important! Read Before Operating This Equipment
WATER AND MOISTURE: Do not use this product near water - for example, If you move to an area with a different mains voltage, contact your local Cyrus near a bath tub, wash bowl, kitchen sink, or laundry tub, in a wet basement; or distributor to have your product converted. -
Page 5: Preparations For Installation
Zone 2 (& tape) Output 13. Digital Input 10 Now is a good time to register your new Cyrus product. Registration takes only a few minutes, brings the added benefit of a full two year factory warranty Analogue Input 6 14. -
Page 6: Digital Audio Inputs
The USB audio input 11 may be used to connect the audio feed from a Two power amplifiers will be required to partner a Cyrus Pre XPd pre- computer. Using a suitable USB cable, connect the USB output from the amplifier in a bi-amplified system. -
Page 7: Connecting A Cyrus Surround Sound Decoder
For this system to function correctly both the amplifier and the Cyrus surround decoder must be included in an MC-BUS connection loop and the ‘Cyrus AV’ input name must be set for the input used (see ‘MC-BUS’ section and ‘Input names’ in the ‘Setup menu’ section). -
Page 8: Factory Settings
NOTE:- There are two special function input names marked *. Name Input 1 Choose a name for input 1 from the name list ‘Cyrus AV’ is reserved for the connection of Cyrus surround sound decoders Name Input 2 Choose a name for input 2 from the name list to one of the analogue Inputs 1-6 and should only be used for this purpose. -
Page 9: Operation
To select a different source, press the front panel Zone 2 key, AV key will select inputs named AV, Cyrus AV, AV Direct or DVD. As a new the display will show the input source currently selected for Zone 2. - Page 10 AV-S indicator. ZOOM NIGHT • Pressing CD will send commands to a Cyrus CD player. This key will also ANGLE switch on the amplifier and select an input named CD. • Pressing TU/DAB will send commands to DAB radios or FM Tuners. This key will also switch on a DAB radio or FM Tuner and select an input named Tuner.
-
Page 11: Dab Mode
AV SETUP MODE SELECT – see table below Record to memory card DAB/FM/Memory card band select Mono/stereo when playing FM Stereo/mono *early Cyrus CD players will respond to Play/Stop only AV (DVD & amp) MODE AV-S (DVD & decoder) MODE AV-SETUP MODE Power off all systems... -
Page 12: Troubleshooting Guide
Equipment for attention under warranty should be consigned return carriage paid. If returned equipment is found to comply with the published No sound from one loudspeaker specification, CYRUS reserves the right to raise a charge. BAL control at extreme limit Centralise Balance The above conditions do not affect your statutory rights as a consumer. -
Page 13: Specifications
Input Impedance ..................75Ω Sample rate range ................32k - 96k Audio formats ............... PCM stereo only S/N ratio (Pre-out, 0dB FS) .............. >100dBA THD+N (Pre-out, 0dB FS) ..............<0.002% Cyrus reserves the right to change all specifications without notice. E &OE... - Page 14 Cyrus Audio Ltd., Ermine Business Park, Huntingdon, PE29 6XY, U.K.