Anadex DP-9000 Operator's Manual page 65

8. Press the POWER switch off and set the configuration
switches at the back of the printer as follows:
NOTE
OFF is when the numbers are visible from
the back of the printer.
Switch Sl (far right)
Switch S2 (middle)
Switch S3 (10 section
switch)
- Sections 2, 3, and 5 ON
All others OFF
- All OFF
- Section 2 ON
All others OFF
(Mandatory for DP9000j
DP900l. Optional for
DP9500jDP950l)
9. Manually position the paper so that the perforation
is exactly at the top of the print bar, (or some other
convenient locating point). Press the POWER switch
ON. Momentarily press the ON LINE switch to the OFF
LINE condition (light out). Momentarily press the
FORM FEED switch. The paper should advance exactly
11 inches. (You may experiment with other form
lengths if desired but each time any of the config-
uration switches are changed, power must be cycled
OFF then ON to reinitialize the printer.)
10. Press and hold the FEED switch. A short pause will
occur after one line feed then paper should advance
continuously as long as the switch is held.
11. Momentarily press the ON LINE switch for the ON LINE
condition. Press the TOF switch and SELF TEST switch
momentarily. After a pause of approximately 4 seconds
the printer will print out the results of the SELF TEST.
The first line should read - ROMS CRCC MATCH,
RAM ERROR 0000.
The second line should read - 00000000 01101000.
The third and fourth lines should indicate no
tabs set.
The fifth line gives the FIFO size in hexadeci-
mal notation. The exact value will vary
according to the firmware (ROMS) installed,
however the standard FIFO is approximately
02C0H (704) and with Option R installed it is
approximately 0AC0H (2752).
4-3