FIGURE
2-4.
POWER LINE MODULE
Turn the Voltage Selector Card so that the desired line volt-
age will be readable when the card is inserted, and reinsert
the card fully into the Power Line Module.
Replace the fuse
and slide the cover to the right side.
The line power cord
can now be connected.
CAUTION
THE LINE POWER CORD SHOULD ALWAYS BE CONNECTED
TO A GROUNDED OUTLET.
DO NOT USE AN UNGROUNDED
ADAPTER TO CONNECT THE POWER CORD TO A TWO-WIRE
OU"TLET.
IF THE POWER CORD GROUND IS BYPASSED
OR UNGROUNDED, STATIC ELECTRICITY PROBLEMS CAN
DEVELOP WITHIN THE PRINTER, CAUSING SEVERE DAMAGE
TO THE PRINTER, AND/OR THE ELECTRONIC COMPONENTS
WITHIN.
2-8