Front Panel Controls And Indicators - Anadex DP-9000 Operator's Manual

SECTION III
OPERATION
3.1 GENERAL REQUIREMENTS
Effective operation and use of your printer requires a
complete understanding of the use and functions of the
switches, controls, and indicators on the printer.
Many of the functions of your printer can also be con-
trolled by control code addressing from the data source.
A thorough understanding of the control codes recognized
by your printer is essential to utilizing all of the
many features of your printer. In the serial interface
mode, several methods of validity checking and protocols
are available.
3.2 CONTROLS AND INDICATORS
The controls and indicators for your printer are divided
into two groups. Those which may require regular and
frequent access are externally located, and those which
are infrequently used are located internally, but are
accessible from the outside at the rear. Certain other
controls which are only used in test and alignment are
internally located. These are not normally required by
a user/operator. The final group are those controls
accessible through the communications interface.
3.2.1 EXTERNAL CONTROLS AND INDICATORS: The following
controls and indicators are located on the front panel or
external to the printer. (See Figure 3-1.)
B GO
II
II
POWER
FEED TOF SET FORM FEE 0
DGB
t -
VERli';·ALAI_IGN -
~
SELF TEST
ONLINE
FIGURE 3-1. FRONT PANEL CONTROLS AND INDICATORS
3-1