Anadex DP-9000 Operator's Manual page 21

c. For each additional copy of paper or 0.003 inch
of thickness, open the gap one notch.
d. Print one or two lines of printing. Readjust
the head gap
adjust~ent
to the most open posi-
tion which provides' satisfactory print quality.
The wider the gap the longer the life which
can be obtained from the print head. Close the
gap one more notch. Make a note of this posi-
tion for use when changing: the ribbon or replen-
ishing paper.
2.7 POWER CONNECTION
Your printer requires 120 Watts of power. AC voltage may be
100, 120, 220, or 240 Volts·AC at a frequency between 48 and
62 Hertz. Your printer was shipped to match the power normally
expected for your area. However, before applying power to the
printer, you should verify the correct setting. The po~er line
connector is located at the right rear corner of your printer
and is a multifunction module containing the line conn-ector,
power fuse, and a line voltage selector card. (See figure 2-4.)
To check the line voltage setting (line cord must be discon-
nected), slide the plastic cover on the Power Line Module to
the left. The selected line voltage can then be read on the
Voltage Selector Card.
CAUTION
ATTEMPTING TO REMOVE THE VOLTAGE SELECTOR CARD
WITHOUT USING THE PROPER TOOL MAY DAMAGE THE
CARD.
CARE MUST BE TAKEN TO AVOID DAMAGING THE SHORT-
ING BARS ON THE VOLTAGE SELECTOR CARD.
To select a different line voltage, slide the clear plastic
door to the left (power cord must be removed) and pull the
FUSE PULL extractor lever all the way to the left. Remove
the fuse. Using an extractor tool made from hooked music
wire or equivalent, or a pair of Duck Bill or Long Nose pliers,
pull the Voltage Selector Card straight out (the FUSE PULL
lever must remain all the way to the left.)
2-7