Related Manuals for Bartscher FTH - 30G
Summary of Contents for Bartscher FTH - 30G
- Page 1 INSTRUCTIONS FOR INSTALLATION AND USE GAS GRIDDLE PLATES FTH - 30G, GL / A3700331 FTR - 30G, GL FTH - 60G, GL / A3700341 FTHR - 60G, GL FTH - 90G, GL FTHC - 30G, GL FTRC - 30G, GL...
-
Page 2: Cleaning And Maintenance
CONTENT DECLARATION OF A STANDARDS CONFORMITY INSTRUCTION FOR USE CLEANING AND MAINTENANCE DIE NORMENÜBEREINSTIMMUNGSDEKLARATION GEBRAUCHSANWEISUNG REINIGUNG UND WARTUNG DÉCLARATION DE CONFORMITÉ MODE D´EMPLOI ENTRETIEN... -
Page 3: Technical Data
DECLARATION OF A STANDARDS CONFORMITY The producer confi rms that the devices agree with 2009/142/ES standards, rule nr. 22/1997 sb., nr. 258/2000 sb.. nr. 258/200 sb. and with relevant goverment orders. Instalation must be done with respect to valid standards. Attention, the producer refuses any responsibility in case of direct or indirect damages which are caused due to wrong instalation, incorrect intervention or modifi... - Page 4 BURNERS 12,8 kWh/kg 12,8 kWh/kg 12,8 kWh/kg 9,45 kWh/m FEEDING G 30/G 31 G 31 G 30/G 31 G 20 MODEL NOZZLE Burner TUBE PROPAN / BUTAN PROPAN PROPAN / BUTAN Natural GAS 28 - 30 mbar 37 mbar 50 mbar 20 mbar NOZZLE OF BURNER 1/100 MM 4,0 kW...
- Page 5 DEVICE INSTALATION Instalation, setting, rebuilding for another gas type, putting into operation must be done by qualifi ed person who is competent for this and according to the valid standards. The device can be instalated in good ventilated room.When it is possible place the device under the fumehood to suck off the products of combustion. Air needy to the burning is 2m/3/h/kW ot the performance of the instaled device.
-
Page 6: Pipe For Gas Connection
PIPE FOR GAS CONNECTION It must fi rst determine if the appliance is made for the same type of gas that will be used and thus conforms to the indications on the label the type of gas to be used. The conversion of gas pan to another type of gas you need to check if it corresponds to the type of gas bearing, which is recommended in this guide. -
Page 7: Maintenance
CHECK THE GAS TYPE THE DEVICE IS ADJUSTED FOR Check whether the device is set for the gas type you use. The gas type is indicated on the label of each device. Process of rebuilding the device for another gas type The device is set and checked for liquefi ed gas (see the label). -
Page 9: Leaning And Maintenance
LEANING AND MAINTENANCE Clean the device daily. Stainless parts wash with moist cleaning cloth and detergent without groove parts then splash it with clean water and dry it by the cloth. When cleaning the interior space, the burner can be removed ( lift the back part and by back work movement back out from frot brackets After cleaning impregnate the surface of the hot-plates with oil. - Page 10 Dimension FT** 30 G FT** 60 G FT** 90 G...
- Page 11 FT** 30 GL FT** 90 GL...