General Information; Diagnosis; Id Number And Id Data Settting - Pioneer DV-656A-S Service Manual

5

7. GENERAL INFORMATION

7.1 DIAGNOSIS

7.1.1 ID NUMBER AND ID DATA SETTTING

Entering the ID Number and ID Data for Players with DVD-Audio and DVD-RW
Compatibility
It is necessary for a player with DVD-audio and DVD-RW compatibility to set an individual number (ID number) and ID data. If the
number and data are not set correctly with the following procedure, operations in the future may not be guaranteed. You will find the ID
number to be set on the yellow label on the rear panel.
Important: If no yellow label is found on the rear panel, write down the specified ID number by checking it according to "How
to confirm the ID number" shown below.
The Input is Necessary When:
• Downloading FLASH-ROM is finished. (The latest version must be downloaded when a repair is made.)
• "No ID Number" is displayed on the screen or FL display immediately after the power is turned on or in Stop mode.
• If "No ID DATA" is displayed, the ID data must be entered.
Note:
Be sure to enter the ID number in Stop mode.
Use the service remote control (GGF1067) for operations. Only opening/closing of the tray are performed from the player.
Use Disc No. : GGV1084
How to Input the ID Number and ID Data
1
To enter the input mode, press ESC + STEREO in a status with
no ID number set, such as after FLASH-ROM downloading.
2
As number input is enabled when the unit enters the input
mode, input the 9-digit ID number.
(The entered number is also displayed on the FL display.)
[Player's ID Number Setting]
ID Number ?
> - - - - - - - - -
2
<CLEAR> Exit
Input ID Number !
3 After inputting the number, press SEARCH to register the ID
number.
[Player's ID Number Setting]
ID Number ?
> 0 0 0 0 0 0 0 0 1 OK ?
<PLAY> Compare Mode
<SEARCH> Enter
3
Input ID Number !
5
6
4
When the ID number has been registered, the unit enters the
ID data input mode. (The FL display indicates "NO ID DATA.")
In this condition, place the ID data disc on the tray and close
the tray using the CLOSE key "7/0" on the player.
4
5 While the data are being read, the message shown in the
figure at left is displayed on the screen.
(The FL display indicates "RD ID DATA.")
5
DV-656A-S
6
7
[Player's ID Data Setting]
<CLEAR> Exit
Insert The ID Data Disc !
[Player's ID Data Setting]
Loading The ID Data Disc !
7
8
A
B
C
D
E
F
65
8