Mercury 225 OPTIMAX DTS Installation Manual page 18

200/225 OPTIMAX DTS
NOTE: For dual helm application - Remove CAN 1 and CAN 2 terminator resistors from
helm 1 (helm closest to the engine), and seal connectors with weather caps.
e
MODULE INSTALLATION
• Although the Command Module connection is watertight, it is recommended that it be
mounted in an area that stays relatively dry.
• Mount in an area where the wiring connection will not get stepped on or disturbed.
• Mount in an area that is accessible for troubleshooting and servicing the system.
Page 18 / 42
Terminator
Terminator
CAN 2
CAN 1
f
g
Dual Helm Application
a - Helm 2 (upper helm)
b - Helm 1 (lower helm)
c - DTS command module harness
d - Clamp or cable tie
a
c
h
c
b
e - CAN 1 connector
f - CAN 2 connector
g - Weather caps
h - Terminator resistors, blue (CAN1 &
CAN2)
d
d
3677
90-10234050